[fbb] TNCs

[Charles E. Gelm]

 I am not familiar with PK-96 or KA-NET-ROM.
Yes, you can use both ports of the KAM (& KPC-4, & 3 ports of the 
KPC-9612##) with G8BPQ node code.  AFAIK, the PK-* do not use both
ports simultaneously.  I am sure you will find the answer soon, here,
on this list. ;-)

 I am familiar with BPQ & KPC-4.  Yes, you can use both ports
of the KAM.  I have used KPC-4, DRSI-2, & MFJ-1270B for 5 radio
ports with BPQ.  The KPC-4 and KAM are configured the same in
BPQCFG.TXT.  Not a problem.  Piece of cake. :-)

HTH, Chuck

tbaca@boi.hp.com wrote:
> 
> I have two questions.  I have WinFBB setup through BPQ.  If I
> install a PK-96 TNC on BPQ, can a user connect to that with either
> 1200 or 9600?  Can it support multipule connections at different
> speeds?
> 
> Second Question, I also have a KPC-9612 with the KA-NET ROM.  Any
> one know how to setup the NET/ROM side of this TNC.  I have it
> up and running, but can't change the Info or Port description.  Also,
> can this run under BPQ and have both ports useable?  I am presently
> running it directly into WinFBB using Host mode
> 
> Thank
> WV7I
> 
> --
> _____
>    /ony Baca     Hewlett Packard Co. Boise, Idaho      tbaca@boi.hp.com
> 
> _______________________________________________
> fbb maillist  -  fbb@f6fbb.org
> http://www.f6fbb.org/mailman/listinfo/fbb